NEW LOW PRICE!!!

The Dolphin experimenter's board for the Flipper Zero provides a neat and clean way to do testing and development on the Flipper Zero

The kit now includes the Dorsal Q433RT Dolphin daughterboard for testing 433Mhz Sub-GHz!

The Dolphin board comes completely assembled.  There is no soldering required on the Dolphin board itself.  All components on the Dolphin board including all the black headers and surface mount components are already soldered on.  The Dolphin board comes as shown in the photos.  The only soldering required is on the two separate temperature/humidity sensors and the WEMOS D1 that come in the package.

Dolphin experimenters kit for Flipper Zero

What's included in the kit:

• Version 1.4 of the Dolphin Flipper Zero experimenters board (not available separately at this time)  Some photos show v1.3.  The only difference between 1.3 and 1.4 is the location of the silkscreen of the power indicator LEDs, no soldering required
  
• Dorsal DR28 dual row header adapter for modules such as CC1101 that have a dual row header, up to 2x8, soldering required
• One “ESP32 WROOM” module for Marauder, if requested it will be programmed for no charge but may take a day or two longer to ship.  No soldering required
• One “ESP8266 WEMOS D1 Mini” module for deauther, soldering is required for the pin headers, if requested it will be programmed for no charge but may take a day or two longer to ship
• One “NRF24L01+” for mousejacker and wireless Bad USB. No soldering required
• One "AHT10" I2C temperature/humidity module, has pullup resistors, soldering required for the pin headers.
• One "HTU21D" I2C temperature/humidity module, has pullup resistors that are disabled, can be enabled by the solder jumper pads, soldering required for the pin headers.
• One “HC-SR04 Ultrasonic Range Finder” Module, no soldering required
• Two rewritable NTAG 215 round NFC tags, TAGMO compatible (Flipper Zero can't yet write to NFC)
• One RFID 125Khz key fob, rewritable
• Ten 10cm female to female Dupont jumper wires
• Ten 10cm male to female Dupont jumper wires
• Ten 10cm male to male Dupont jumper wires
• Four 2-pin jumper shunts. These are for i2c voltage select, i2c pull-ups enable/disable, UART voltage select, and LED power indicators enable/disable. Don’t forget to install these on your board.

See documentation page for more info

Here is a video from Derek Jamison with his first impressions of the Dolphin experimenters kit for Flipper Zero

Below is a link to a YouTube playlist where Derek Jamison is using the Dolphin board for his testing and prototyping:

https://tinyurl.com/flipper-dolphin